Where is the VEN mounted?

• A. Aft end of the afterburner case.
• B. Front of the engine intake.
• C. On the exhaust tailpipe behind the turbine.
• D. Inside the compressor housing.

Answer: (A)

The VEN is mounted at the aft end of the afterburner case because this location places the unit in a protected area near the engine tail where it can connect to the aircraft’s electronics with short, clean routing, while avoiding the main airflow paths and the most extreme heat zones. Being aft of the core flow but not directly in the exhaust jet helps with service access and reduces exposure to debris and intense heat that would occur farther forward or deeper inside the engine.

If it were placed in front of the engine intake, it would sit in the high-risk intake flow where debris and disturbed air could affect its operation. Inside the compressor housing, it would obstruct airflow and be nearly impossible to service. On the exhaust tailpipe behind the turbine, it would endure extreme heat, vibration, and maintenance challenges. The aft end of the afterburner case thus offers the best balance of accessibility, protection, and proximity to related systems.